Maintenance - Schulte Heizstab 5 Betriebsanleitung

Remote control mode (wireless communication)
If there is a dedicated IR controller inside
the room, which sends signals to the heat-
er, then, the first signal correctly received
by the heater, automatically switches the
device into receiving mode. When in this
mode, the device will heat with the heat
output dictated by the external controller
while still controlling temperature not to
exceed approximately 60° C . Remote mode
is indicated by the diode shining with con-
stant blue light. Every correctly received
Malfunction alerts
The device constantly monitors all param-
eters which may indicate its damage or
any adverse phenomena, and automati-
cally activates necessary protective proce-
dures. Those are, amongst others: protec-

Maintenance

• Always disconnect the device from
electricity before you start cleaning the
radiator.
• Recurrently check level of the heating
medium inside the radiator.
signal from the external controller is indi-
cated by short flash of the diode. If there
is a break in communication (the heater
does not receive a signal from the exter-
nal controller for 30 minutes), the heater
will switch to a signal-awaiting mode. The
blue diode will start pulsating steadily and
the device will automatically turn off with
the antifreeze function still active until the
connection is reached again.
tion against operation in 'dry conditions',
monitoring of controlling and measuring
systems. All malfunction alerts are indicat-
ed by a flashing white diode.
• Clean the item with a dry or damp cloth
with a small amount of detergent with-
out any solvents or abrasive agents.
41