Blaupunkt EJE801 Bedienungsanleitung Seite 7

EJE801
1. Pusher
2. Juicer's cover
3. Filter basket
4. Juice collector
5. Safety locking handle
6. Base with motor
7. Switch knob
BEFORE FIRST USE
1. Remove all papers, cartons, foil which secure the juicer and juicer parts
2. Clean the juicer following the advice in Cleaning and Maintenance chapter.
3. It is recommended to assemble and disassemble the juicer before using.
ASSEMBLING THE JUICER AND DISASSEMBLING
1. Fit the juice collector (4) to the base (6).
2. Fit the filter basket (3) to the motor drive coupling and push down until it into place. Ensure
the filter basket (3) is fitted securely inside the juice collector (4).
3. Place the juicers cover (2) over the juice collector (4).
4. Raise the safety locking handle (5) up and locate into the two grooves on either side of the
juice cover (2). The safety locking handle (5) should now be in a vertical position and locked
into place on top of the juicer's cover (2).
5. Place the juice jug under the juice outlet .
6. To disassemble do all the previous operation at the reversed order
USING THE JUICER
Make sure that the anti-drip mechanism was released before running the juicer.
Switch on, put some fruits and vegetables into the feeder and push down with the pusher.
Use lower speed settings for softer fruits and higher speed setting for hard vegetables;
1. Soft fruits
2. Citrus fruits
3. Pineapple
4. Apples and pears
5. Hard vegetables
Some very hard foods may make your juicer slow down or stop. If this happens switch off and unblock
the filter.
Insert soft food slowly to get the most juice.
Switch off and clear the pulp collector regularly during use.
USING THE BLENDER
Place the blender's jar (12) on the body of the device fitting to the rotor (11) in the clutch of knives at
the bottom of the blender jar. Lock the blender jar on the body by turning it to the right (clockwise).
Put the ingredients into jar. Pour some water. It is recommended not to fill more than ¾ of capacity.
Note: Hold the blender jar during operation.
Run the blender by main switch, then select the speed by knob.
When the ingredients will gain the right consistency, turn off the device. Do not operate the blender
for more than 30 seconds. Wait 10 minutes before the next start.
8. Pulp container
9. Juice cup
10. Main switch
11. Rotor
12. Blender's jar
13. Blender's lid
14. Small blender's lid
5