Electrolux IK2070SR Benutzerinformation Seite 13

Problem
The compressor does not
start immediately after
pressing the "FastFreeze"
or "FastCool", or after
changing the temperature.
Water flows inside the re-
frigerator.
Water flows on the floor.
Temperature cannot be set. The "FastFreeze function"
dEMo appears on the dis-
play.
The temperature in the ap-
pliance is too low/too high.
Possible cause
Food products placed in
the appliance were too
warm.
The "FastFreeze" or "Fast-
Cool" is switched on.
This is normal, no error
has occurred.
Food products prevent
the water to flow into the
water collector.
The water outlet is clog-
ged.
The melting water outlet is
not connected to the
evaporative tray above the
compressor.
or "FastCool function" is
switched on.
The appliance is in dem-
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The door has been
opened often.
ENGLISH
Solution
Allow food products to cool
to room temperature before
storing.
Refer to "FastFreeze function"
or "FastCool function".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water out-
let to the evaporative tray.
Switch off "FastFreeze func-
tion" or "FastCool function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"FastCool function".
Keep the OK pressed for ap-
proximately 10 seconds until
a long sound is heard and
display shuts off for a short
time.
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Open the door only if neces-
sary.
13