Makita DFL651F Bedienungsanleitung Seite 7

Lighting up the lamp(s)
CAUTION:
• Do not look in the light or see the source of light
directly.
LED indicator / Beeper
► Fig.7: 1. LED indicator
LED indicator / Beeper on the tool shows the following functions.
Function
Auto-stop fastening
Warning against insuffi-
cient fastening
Warning for battery
cartridge capacity
Checking the remain-
ing battery capacity,
Autostop
Check the LED indi-
cator, light and beeper
operation
Anti-reset of controller
Overheat
Operation error of the
switch trigger
Motor failure
Status
This function works Lights up in green for
when the tool has approximately one
reached the preset second.
fastening torque and
normal tightening has
been completed. This
helps overtightening to
be avoided.
Insufficient fastening has Lights up in red.
been performed when
the switch trigger has
released before reaching
the preset fastening
torque.
This indicates the appro- Flickers in red slowly.
priate time to replace
the battery cartridge
when the battery power
becomes low.
This function works Lights up in red.
when the battery power
is almost used up. At
this time, tool stops
immediately.
This function works to Lights up first in green,
check the proper opera- next red.
tion of the LED indicator, (And then the light
light and beeper when comes on.)
a battery cartridge has
been inserted into the
tool.
This function works Flickers in red and green
when an abnormal drop alternatively.
of the battery voltage
occurs for some reason,
and the tool stops.
This function works Flickers in red quickly.
when the temperature
of the controller goes up
very highly, and the tool
stops.
This function works to Flickers in red and green
avoid the tool's immedi- alternatively.
ate start upon insertion
of battery cartridge into
the tool with the switch
trigger being pulled.
Motor failure has been Flickers in red and green
detected. At this time, alternatively.
tool does not work.
► Fig.6: 1. Lamp
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The lamp automatically goes out 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of
lamp. Be careful not to scratch the lens of lamp,
or it may lower the illumination.
Status of the LED indicator/beeper
LED indicator
A long beep
A series of long beeps
A long beep
A series of very short
beeps
A series of short beeps
A series of short beeps
A series of short beeps
A series of short beeps
7 ENGLISH
Action to be taken
Beeper
–
Retighten the screw.
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
Replace the battery with
fully charged one.
Remove the battery car-
tridge immediately and
cool the tool down.
Release the switch
trigger.
Ask your local Makita
Service Center for repair.
–
–