Harvia SGC0909BR Montage- Und Bedienungsanleitung Seite 17

EN
Time display
TEMP- button
TIME- button
USB socket
LIGHT button
Turning the infra radiators on
Press POWER button for few seconds to turn on the in-
fra radiators. Temperature and time show the previous
settings.
Setting temperature
After the radiators are turned on, press TEMP- and TEMP+
to adjust temperature. Temperature range is from 30 to
75˚C, stepping temperature is 1˚C. Fahrenheit degree
range is from 86 to 167˚F and stepping is 5˚F. Screen
shows LO when temperature is lower than 30˚C or 90˚F.
Press TEMP- and LOCK at the same time for 5 seconds
to switch between Celsius and Fahrenheit.
Setting time
Set the time with TIME+ and TIME- buttons. Range is
from 5 to 60 minutes and stepping is 5 minutes. Infra
cabinet beeps 3 times when the time is running out (5
minutes before).
Light control (can be controlled separately)
Press LIGHT button to turn on the lamp. Indicator light is
on when the lamp is on.
Turning on LED light color: When the lamp is on press
LIGHT button for 5 seconds and wait that the time display
shows 2n and temperature display shows Lx (x is 1-9).
Press LIGHT button to change colors.
Turn on/turn off the lamp by pressing LIGHT button or
pressing TIME- and TIME+ buttons.
Audio function (can be controlled separately)
Bluetooth: Press AUDIO button and wait the indicator
light to turn on. Temperature display shows BLU. Switch
on Bluetooth from your mobile device and connect with
infrared cabin.
INSTRUCTIONS FOR USE
POWER button
USB: Press AUDIO button and wait the indicator light
to turn on. Press AUDIO button again and wait for the
temperature display to show USB.
Radio: Press AUDIO button and wait the indicator light
to turn on. Press AUDIO button two times more and wait
for the temperature display to show a radio frequency.
Searching frequencies: When radio is on, press AUDIO
button for few seconds and wait. The frequency range
is 87,5MHz-108MHz. When frequency has been found,
it will be saved.
Adjust volume with TIME+ and TIME- buttons. Switch
between songs/frequencies with TEMP+ and TEMP- buttons.
If the infrared cabin is on and buttons haven't been pressed
in 8 seconds, displays show temperature and time.
Press AUDIO button four times to turn off the sound
system.
Keylock
Press LOCK button for 5 seconds to switch on the key-
lock, indicator light is on. Press again for 5 seconds to
switch off the keylock, indicator light is off.
Overheating protection
When temperature rises over 80˚C overheating protection
will cut off the supply of the infrared cabin. Displays show
HH, it will alarm and flash. All functions stop.
Disconnect the power supply and then connect the
power supply again to reset the overheating protector.
Temperature sensor error
Displays show E0/E1 and flash, the alarm rings. Check the
wires to the temperature sensor and their connections for
faults. Replace the sensor.
Temperature
display
TEMP+ button
TIME+ button
AUDIO button
LOCK button
17