Ordering Spare Parts - Aerfast CRT4 Anleitung

•
No staples at the end of the jaws:
 Check the contents of the loader;
 Check air supply and service pressure.
 Use once without stapling anything and check the closure of previous staple. In fact in the
operation of the device, an incomplete closure means that the staple-set knife doesn't fully go
backward;
•
Last staple isn't taken:
If for whatever reason (the device falls for example) the staple-pusher unit is not perfectly aligned
with the loader, i.e. slider is no longer parallel to the loader, this problem can arise. To resolve the
problem realign the 2 parts.
•
Staples does not close properly:
Check that jaws' mounting-screws are tightened correctly (screws + nuts (Nyloc nut) with
washers).
•
Replace any defective part immediately!
Note: When disassembling / reassembling, put Loctite 243 on the screws.
When disassembling the staple thrust, bring the knife back completely before putting the latter into
place.
See exploded views for wear and tear parts references.
Your spare parts order can be sent directly to our After-Sales Department. Your local AerFast dealer can
also provide You with spare parts. To order spare parts, thank you to make clear the code and the
description of the part included in the bill of material and the type and serial number of your device.
You are not permitted to dispose this unit together with household waste.
Information on safe disposal of all devices is available from your local council, waste disposal unit and the
shop in which you purchased this product.
You may deposit this product free of charge in your community collection facility.
Correct disposal of used goods protects the environment as well as your health.
CRT4 (ind. D) – 31/08/2018
BREAKDOWNS
WEAR AND TEAR PARTS

ORDERING SPARE PARTS

DISPOSING OF THE UNIT
13