Set The Wall-Mount Bracket Connection Lever - Sharp AN-52AG1 Bedienungsanleitung

Set the wall-mount bracket connection lever

• Be sure to perform Steps 1 and 2 below. If the wall-mount bracket connection lever is not
Caution
fastened, the LCD television could fall down and injure someone.
• The wall-mount bracket connection lever screws are installed in the +5cm holes at shipment.
Remove the 2 screws (M4, 6mm length) from the wall-mount bracket
1
connection lever.
Adjust the height of the wall-mount bracket connection lever to align
2
it with the height to be set and then use the 2 screws (M4, 6mm
length) removed in Step 1 to fasten it in place.
(Up 5 cm)
E-12
+5 mark
+5
(Green)
(0 setting)
0 mark
0
(Yellow)
(Down 5 cm)
-5 mark
-5
(Blue)