Quax BASIC Handbuch Seite 17

BASIC
05 05 23xx
4. Assembling the changing table
1. Insert two cylindrical nuts (2) into both the left-hand and the right-hand upper cross-lathes (E) and then
place them in-between the front and the rear leg frames (A and B) by pushing the wooden taps into the
holes especially provided to that effect. Then insert four bolts (1) through the holes of the leg frame and
slightly tighten with the hexagonal spanner (4).
2. Now slide the top (C) through the grooves of the front leg frame (A) and the grooves of the left-hand and
right-hand upper cross lathes (E).
3. Insert four cylindrical nuts (2) into the holes especially provided to that effect in the two shelves (D) and
then place them in-between the front and the rear leg frames (A and B). Then insert four bolts (1) through
the holes of the leg frames and slightly tighten.
4. Secure all joints.
5. Fix the top (C) by pushing the woodscrew (3) through the hole especially provided to that effect in the
bottom of the front leg frame (A) and screwing it tight.
6. Push the wheel inserts (5) into the holes especially provided to that effect in the bottom of the rear leg
frame (B) and then push the wheels into these inserts until they click into position.
Luiertafel type 1
Wickelregal Typ 1
info@basicbaby.be info@basicbaby.be info@basicbaby.be
17
By Quax nv
Karel Picquélaan 84
B-9800 Deinze
T 00 32 9 380 80 95
Table à langer type 1
Changing table type 1
www.basicbaby.be www.basicbaby.be www.basicbaby.be