Equipment/Optionals; Initial Start Up And Installation - Schick Dental Q Basic Betriebsanleitung

4. Equipment/Optionals

foot pedal switch (on/off) for
connection to the table top model
art.no. 6370/2
chuck Ø 2,35mm
chuck key
counterstay wrench
motorcable complete
riveting hammer
art.no. 1850
5. Initial start-up and installation
5.1 Installation of the suspension strip for knee control unit
1.
1. The suspension strip (7) is supplied with a template which acts as an aid for correct positioning of
the knee control unit. To do this, the mounting bracket is positioned on the work bench as
shown in figure 1, and secured using the screws supplied (8). After installation, the template can
simply be detached from the bracket.
2. For installation of the
bracket andpushed back until it clicks into place (Fig.2).
dynamic foot control for
connection to the table top model
art.no. 9440
6642
4115
6223
9225
twin riveting hammer
art.no. 1860
knee control unit, the cavity at the rear of the unit is placed on the
riveting hammer with chisel
2.
5
art.no. 1850/1
2.
1.