auna Connect Soundchef Anleitung Seite 75

Preset
• To store a FM preset, press and hold PRESET/BT PAIR until the display
shows the Save preset screen. Select one of the 10 presets to save the
currently playing station.
• To select a preset, press PRESET/BT PAIR briefly, then select one of the
listed preset stations. When a preset station is playing, it shows *n (*1,
*2, etc) at the bottom right of the screen.
• 1 to 10/0 on the remote control are for the use of preset station 1-10.
Now playing information
While the stream is playing, the screen shows its frequency, or if RDS
information is available, station name and any further RDS information
such as programme name, track title and contact details. If no information
is available, just the frequency is shown. Stereo broadcasts are indicated
with an icon at the top of the screen, To view further information about the
broadcast, press VOLUME/INFO or INFO/TIMER on the remote control.
Each time you press it, another set of information is displayed, cycling
through RDS text, further RDS text (station/programme type), frequency
and today's date.
Settings
Scan settings
By default, FM scans stop at any available station. This may result in a poor
signal-to-noise ratio (hiss) from weak stations. To change the scan settings
to stop only at stations with good signal strength, select Yes after choosing
Strong station only?
Audio settings
All stereo stations are reproduced in stereo. For weak stations, this may
result in a poor signal-to-noise ratio (hiss). To play weak stations in mono,
select FM weak reception: Listen in mono only and then YES.
EN
75