Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Height adjustment made easy
Note: An 8-mm hex key is required to loosen the screws.
1. Pull out the telescopic valve rod together with the
valve and raise the rubber sleeve
2. Loosen the lock ring
3. Turn the telescopic pipe 180° anti-clockwise
as far as it will go
4. Adjust the telescopic pipe to the desired height
5. Turn the telescopic pipe
back 180° clockwise as
far as it will go.
IMPORTANT Pay attention
to the markings.
6. When the markings are aligned, retighten the
lock ring. Maximum tightening torque: 20 Nm
Pull the rubber sleeve over the joint
7. Insert the extended telescopic valve rod
Werbung
