Installation - Klarstein 10032455 Bedienungsanleitung

EN
34

INSTALLATION

After purchasing your gas cylinder you will then be ready to set it up with your gas grill.
1. When changing the gas cylinder which shall be carried out away from any source
of ignition. Position the gas cylinder at left side or inside of your BBQ, keeping in
mind that the bottle must be kept away from heat and in a safe position.
2. When ready to use your gas grill insert the regulator into the gas bottle valve and
tighten fi rmly.
WARNING: Danger of hazardous fi re or explosion
Before attempting to light your gas grill you must refer to your lighting
instructions and warning / safety points. Check the hose before each use,
searching for cracking, cuts or any abrasions. If the hose is found to be
faulty in any way do not attempt to use your gas grill.
When changing your gas bottle ensures that there are no sources of
ignition close by i.e. fi res, cigarettes, naked fl ames etc. Make sure that the
appliance is switched off.
• Ensure that the hose is not subjected to twisting which will affect the gas fl ow when
installing your gas grill. Also the hose must not have undue tension and must not
touch any part of the gas grill which may be hot.
• Please choose fl exible hose whose heatproof higher than 80 °C.
• Flexible tube should be changed every 2 years; It's necessary to change the
fl exible tube when the national conditions require it.
How to change your cylinder
Note: Turn off the switch of cylinder (No spanner is required)
• If the gas cylinder is put into the grill: the height of the gas cylinder is below the
48cm, and the width is within 33cm.
• If the gas cylinder is put outside the grill: the height of the gas cylinder is below the
80cm, and the width is within 35c.
How to connect a gas bottle
1. Turn the orange cap so that the arrow is pointing to the gap in the shroud.
2. Remove the orange safety cap by pulling the lanyard out, then out. Do not use
tools. Leave the cap hanging.
3. Check that the black sealing washer is fi tted inside the cylinder valve. Connect the
regulator to the valve.
4. Turn the switch clockwise on gas bottle-then turn on the gas grill as instructed.