Electric Connection; Use; Maintenance; Troubleshooting - PLYMOVENT TEV-385 Betriebsanleitung

• Use the mounting holes (B) and suitable hardware (not
supplied, material depending on floor type) to tighten the
vibration dampers to the floor.
- mounting holes TEV/AV-79: Ø 11,5 mm (0.43 in.).
Fig. 4.1 Installing vibration dampers and fixing the fan
4.2.4 Connecting the fan inlet to a hose
We advise the use of a soft connection for the inlet to reduce
the noise and the vibrations of the fan.
To connect the inlet of the fan to a hose or a duct, proceed as
follows:
Fig. 4.2
• Attach the soft connection to the inlet of the fan.
• Tighten the hose clamp (B).
• Attach the soft connection to the hose or duct.
• Tighten the hose clamp (C).
D (x8)
4.2.5 Connecting the fan outlet to a duct
E
We advise the use of a soft connection for the outlet to reduce
F
the noise and the vibrations of the fan and to avoid damage to
the duct. In addition, we advise the use of a (square to round)
outlet transition.
To connect the outlet of the fan to a duct, proceed as follows:
Fig. 4.2
• Loosen the bolts of the outlet grid (A).
• Remove the grid.
• Attach the outlet transition to the fan with the bolts (D) of
the grid.
• Tighten the bolts of the transition.
• Attach the soft connection to the transition.
• Tighten the hose clamp (E).
• Attach the soft connection to the duct.
• Tighten the hose clamp (F).
0000100437/010812/0 TEV-RANGE
D (x8)
E
F
A
Fig. 4.2
B (x 2)
4.3
The default setting is 400V. If another voltage is used, the
wiring must be changed according to the instructions on the
identification plate.
To connect the starting device, proceed as follows:
• Connect the fan to the chosen starting device according to
the information on the identification plate on the motor.
• Connect the starting device to the mains according to the
separately supplied electrical diagram.
• Check the direction of rotation of the motor. For this
purpose the fan contains an arrow indicating the prescribed
direction of rotation. The rotation is visible through the grid
of the motor.
• If necessary, invert the connection of the phases.
5
Refer to the documentation supplied with the selected control
equipment how to control the fan.
6
The fans require no specific maintenance.
7
If the product does not function (correctly), consult the
checklist below to see if you can remedy t he error yourself.
Should this not be possible, contact your supplier.
Connecting the fan to a duct or hose
aTTENTiON!
In case the fan is not placed directly next to the
filter system, make sure the connection duct is
sufficiently supported.

Electric connection

aTTENTiON!
Electric connection to be executed in accordance
with local requirements. Ensure compliance with the
EMC regulatory arrangements.
waRNiNg!
Make sure that the fan is suitable for connection to
the local mains. Information about the connection
voltage and frequency can be found on the
identification plate. The cables must be connected in
conformance with the local rules and regulations
and can only be carried out by qualified and
authorised technicians.
A
B
C

uSE

MaiNTENaNcE

TROubLEShOOTiNg

A
B
C
EN - 6