Menu 01 - Chrono Setting; Menu 02 - User Adjustments - Cola AQUAPLUS 23 Installations-, Bedienungs- Und Wartungsanleitung

4.6.1 Menu 01 – Chrono setting
Allows all chronothermostat functions to be enabled/disabled;
select ON to activate the function and display the relevant
segment/LED [ D ]
When Daily, Weekly or Week End programming is entered, the
appropriate segment/LED [ C ] appears in the top right of the display.
Regarding selections and entering times,
use the buttons according to the table in par. 4.2.
By accessing the submenu: DAY PROGRAM, the daily
chronothermostat functions can be enabled/disabled and set.
It is possible to set two operation stages delimited by the
times set according to the following table where the setting
OFF tells the clock to ignore the command.
Selection Meaning
START1 activation time
STOP1 deactivation time
START2 activation time
STOP2 deactivation time
By accessing the submenu: WEEK PROGRAM it is possible to
enable/disable and set the weekly chronothermostat functions.
The weekly programmer has 4 independent programs whose final effect
consists of a combination of the
4 programmings.
The weekly programmer can be activated or deactivated;
also, by setting OFF in the time field, the clock ignores the
corresponding command.
Carry out programming making sure not to overlap the hours
of activation and/or deactivation on the same day in different
programs.
By accessing the submenu: WEEK-END PROGRAM it is possible to
enable/disable and set
chronothermostat functions.
Activate WEEK-END programming only after deactivating the
weekly programming.
To avoid unwanted startup and shutdown operations, only
activate one program at a time.
Deactivate the daily program if the weekly program is required;
with this setting it is advisable to deactivate the week-end
program.
4.6.2 Menu 02 – User adjustments
With this menu it is possible to do a number of settings as follows
- Set clock
Before operating with the stove, it is necessary to set the current time and date so that there is a reference for
possible chrono programming. The electronic controller has a lithium battery, model CR2032 3 Volt, giving the
internal clock an autonomy of more than 4-5 years; with the stove off, whenever the clock does not keep the time, or
a series of zeros is displayed at restart, the battery must be replaced by calling an authorised service centre.
- Standby mode
On activating this function, the stove shuts down automatically after the water temperature has remained above the
SET value for a fixed time.
The next automatic relighting will be possible only when the temperature falls below the SET temperature by a given
value entered in the parameters table.
Possible Values
time - OFF
time - OFF
time - OFF
time - OFF
the week-end (Saturday - Sunday)
51
D C
Menu level
Input
Menu level
AQUAPLUS 23