Application Conditions; Specifications; Electrical Requirements; Unpacking - Mountfield LEVITA 6T Betriebsanleitung

APPLICATION CONDITIONS

This log splitter is designed for operating under ambient temperatures between +5°C and 40°C. The
surrounding humidity should less than 50% at 40°C. It can be stored or transported under ambient
temperatures between -25°C and 55°C.

SPECIFICATIONS

Model
Motor
Log Size Diameter *
Capacity
Length
Maximum Force
Hydraulic Pressure
Hydraulic Oil Capacity
Ram Travel
Forward Speed
Retract Speed
Noise Level
Length
Overall Sizes Width
Height
Weight
* S6 40%, continuous operation periodic duty: time of one load cycle is 10 minutes, operation time at
constant load is 4 minutes, operation time at no-load is 6 minutes.

ELECTRICAL REQUIREMENTS

With 230 Volt/50Hz motor, the log splitter should be connected to standard 230V±10%/50Hz±1Hz.
Electrical supply which has protection devices of under-voltage, over-voltage, overcurrent (16 A) as
well as a residual current device (RCD) which maximum residual current rated at 30 mA. Electrical
connection rubber cables must comply with EN60245 which are always marked with symbol H 07 RN.
Cables should be identified, as it is a legal requirement.

UNPACKING

At least 2 people required to unpack the log splitter package. Take the following steps to put the Log
Splitter on the ground by tipping every side of the carton by 45 degree. Make sure put Block (B) to
support the Log Splitter package (A) at the point a little higher than the middle. The other side of Block
(B) shall be against steady object, such as a wall. Wedge (C) shall be arranged under the tipped Log
Splitter Package (A) every step to avoid slipping. Then remove the carton off the Log Splitter.
230V~ 50Hz 2700W S6 40% IP54
104.5 cm/81.5 cm/56 cm
3.6 cm / sec.
78.8 dB(A) under no load ; 89.8 dB(A) under full load
28
LEVITA 6T
13-30 cm
6 t
24 MPa
4 L
495 mm
19 cm / sec.
90 cm
119 cm
149 cm
97 kg