Maintenance; Troubleshooting; Accessories - SCHOTT KL 1600 LED Gebrauchsanweisung

KL 1600 LED – Operating instructions
If you wish to operate the light source for a short time without a filter then only pull the slide out to
the first rest position. In this position the filter is still in the light source, but no longer in the light path.

3. Maintenance

Your KL 1600 LED is maintenance-free.
The light source should not be disinfected for use in medical applications.
To clean the outside of the instrument please use a soft dry cloth or commercially available plastic
cleaning cloths.

4. Troubleshooting

Should you be unable to rectify the faults by the measures listed below, please contact your
specialist dealer or the nearest SCHOTT agency. More extensive repairs must be carried out by an
authorized after sales service.
Fault
Lamp out
Light intensity dropping
5. KL 1600 LED accessories
A wide range of accessories is available for your KL 1600 LED. Please see our separate catalogue
for further details (contact address for additional requirements can be found on page 10).
Proper functioning, safety and optimum luminous efficiency can only be guaranteed with SCHOTT
light guides and accessories.
Self-supporting and flexible light guides are available in various lengths and diameters, as well as
spot and slit illuminations.
Optical filters can either by inserted in the filter slide or used as screw-in or clip-on filters in
conjunction with a focusing attachment (accessory) in front of the light guide exit.
Details on the focusing attachment and available standard filter types can be found in our catalogue.
Possible cause
Instrument not switched on
Plug not in socket
No mains electricity voltage
Electronics overheated
Remedial action
Switch instrument on
Plug in socket
Check mains voltage
Switch off instrument. Ensure
adequate cooling, switch on
again after prolonged cooling
time.
9/11