Notes About Using This Model For The First Time; Safety Notes; Important Notes; Functions - Märklin H0 TGV POS Bedienungsanleitung

Safety Notes

• This locomotive is to be used only with an operating system
designed for it (Märklin AC, Märklin Delta,
Märklin Digital or Märklin Systems).
• Use only switched mode power supply units and transformers
that are designed for your local power system.
• This locomotive must never be supplied with power from more
than one transformer.
• Pay close attention to the safety notes in the instructions for
your operating system.
• The feeder track must be equipped to prevent interference
with radio and television reception, when the locomotive is
to be run in conventional operation. The 74046 interference
suppression set is to be used for this purpose.
• Do not expose the model to direct sunlight, extreme changes
in temperature, or high humidity.
• WARNING! Sharp edges and points required for operation.
• The LEDs in this item correspond to Laser Class 1 according to
Standard EN 60825-1.

Important Notes

• The operating instructions and the packaging are a compo-
nent part of the product and must therefore be kept as well as
transferred along with the product to others.
• Please see your authorized Märklin dealer for repairs or spare
parts.
• The warranty card included with this product specifies the
warranty conditions.
• Disposing: www.maerklin.com/en/imprint.html
10

Notes about using this model for the first time

• Minimum radius for operation is 360 mm / 14-3/16".
• Sharp curves and turnouts with sharp curves should only be
negotiated at moderate speed, however.
• Make sure you have enough clearance!
• The locomotive cannot be switched to operation from cat-
enary. Power cannot be supplied from the catenary.

Functions

• Recognition of the mode of operation: automatic.
• 1 high-performance motor fitted to each locomotive; it is
controlled by the central drive electronics.
• Fitted pickup shoe switching. Accordingly, the engines always
receive their supply voltage from the front locomotive.
• Address set at the factory: 79
• Mfx technology for the Mobile Station / Central Station.
Name set at the factory: TGV POS 4415
• Setting the locomotive parameters (address, acceleration/
braking delay (ABV), maximum speed):
with the Control Unit, Mobile Station, Central Station.
• Digitally controlled windshield wipers (maintenance free), with
speed-dependent interval.
• Headlights, changing over with the direction of travel.
• Only the train control functions and headlight changeover
feature are available in analog operation.