Safety Notes; Important Notes; Functions - Trix 11488 Bedienungsanleitung

2. Safety Notes

• This locomotive is to be used only with an operating system designed for it.
• Use only switched mode power supply units and transformers that are designed for your local power
system.
• This locomotive must never be supplied with power from more than one power pack.
• Pay close attention to the safety notes in the instructions for your operating system.
• Do not expose the model to direct sunlight, extreme changes in temperature, or high humidity.
• Analog max. 15 volts DC, digital max. 22 volts AC.
• The wire used for feeder connections to the track may only be a maximum of 2 meters / 78 inches long.
• WARNING! Sharp edges and points required for operation.

3. Important Notes

• The operating instructions and the packaging are a component part of the product and must therefore
be kept as well as transferred along with the product to others.
• Please see your authorized Trix dealer for repairs or spare parts.
• http://www.maerklin.com/en/imprint.html
• The warranty card included with this product specifies the warranty conditions.

4. Functions

• Built-in electronic circuit for operation with an conventional DC power pack, Trix Systems or
NMRA DCC digital.
• The mode of operation is automaticaLly recognized.
• Addresses that can be set: 1 - 127
• Address set at the factory: 3
• Triple headlights only at the front in analog operation, in digital operation triple headlights that change
over with the direction of travel.
• ABV — Adjustable acceleration/braking delay.
Several of the locomotive's characteristics can be adapted to your own ideas by programming the Con-
figuration Variables (CV). The programming for the CVs described below can be found in the instructions
for your controller.
CV Discription
1 Adress
3 Acceleration delay
4 Braking delay
5 Maximum speed
Factory-
Value
Set
1 - 127 3
0 - 255 3
0 - 255 5
1 - 7 6
5