Cleaning And Maintenance; Technical Specifications - HQ Power VDP1000SWN Bedienungsanleitung

c. Projector DMX start address selection
All DMX-controlled devices need a digital start address so that the correct device responds to the signals. This start
address is the channel number from which the device starts to "listen" to the DMX controller. Enter the correct
number and read it from the display located on the base of the VDP1000SWN.
You can use the same starting address for a whole group of devices or enter an individual one for every device.
When all devices have the same address, all the VDP1000SWNs will "listen" to the control signal on one particular
channel. In other words: changing the settings of one channel will affect all devices simultaneously. If you set
different addresses, each device will "listen" to a separate channel number. Changing the settings of one channel will
only affect the device in question.
In the case of the 1-channel VDP1000SWN, you will have to set the start address of the first VDP1000SWN to 1, the
second VDP1000SWN to 2 (1 + 1), the third to 3 (1 + 1) and so on.
You can set these address trough the DIP-switches on the back of
the machine. If you put switch 1 to ON you have start address 1. If
you want 28 as start address, set switch 3, 4 and 5 (4 + 8 + 16 =
28) to ON.
d. Instructions
Insert the plug of the power supply into the power socket of the back of the machine. Turn
the power supply switch of the machine to ON and then the RED indication light on the
controller will be on (POWER (2)). Turn the on/off switch (4) to I and the green light will be
on. The snow will be spurting out. Adjust the potentiometer knob (1) on the controller to
control the volume of the snow output.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, visible parts, mounting supports and the installation location (e.g. ceiling, suspension, trussing)
should not be deformed, modified or tampered with e.g. do not drill extra holes in mounting supports, do not
change the location of the connections.
3. Moving mechanic parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts apart from the fuse.
8. Contact your dealer for spare parts if necessary.

7. Technical Specifications

Power Supply
Power Consumption
Output Volume
Approx. Projection Distance
Tank Capacity
Fuse
Dimensions
Total Weight
For more info concerning this product, please visit our website www.hqpower.com.
The information in this manual is subject to change without prior notice.
VDP1000SWN_v3
max. 230VAC / 50Hz
max. 1000W
50m³
± 7m
2.5l
F8A, 250VAC (5 x 20mm) (order code FF8N)
585 x 350 x 340mm
8.3kg
4
1 2 4 8 16 32 64 128 256
HQ POWER