Cleaning And Maintenance; Technical Specifications - HQ Power VDLPROM2 Bedienungsanleitung

• Overhead mounting requires extensive experience: calculating work load limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install the
device yourself if you lack these qualifications as improper installation may result in injuries.
• The mirror ball has to be connected to the motor via the chain. Make sure the motor is installed perfectly
horizontally. There are 3 holes in the base plate for fixation screws.
• Make sure the rotation of the mirror ball is never hampered and that no side forces can impact on the installation.
• The installation has to be approved by an expert before the device is taken into service.
5. Use
After connecting the devices to the mains, the mirror ball motor will rotate at 3 RPM and the lamp will be on.
By aiming the spot towards the mirror ball, you will obtain a beautiful, colourful effect.

6. Cleaning and Maintenance

1. All screws should be tightened and free of corrosion.
2. The housing, the lenses, the mounting supports and the installation location should not be deformed, modified or
tampered with e.g. do not drill extra holes in mounting supports, do not change the location of the connections, ...
3. Mechanically moving parts must not show any signs of wear and tear.
4. The electric power supply cables must not show any damage. Have a qualified technician maintain the device.
5. Disconnect the device from the mains prior to maintenance activities.
6. Wipe the device regularly with a moist, lint-free cloth. Do not use alcohol or solvents.
7. There are no user-serviceable parts, apart from the lamp and the filters (see "4. Installation").
8. Contact your dealer for spare parts if necessary.
9. Check regularly if the key ring or chain shackles have been deformed. If so, demount the mirror ball immediately.

7. Technical Specifications

PAR-36 Pin Spot
Power Supply
Power Consumption
Dimensions
Weight
Lamp
Max. Ambient Temperature
Max. Housing Temperature
Mirror Ball
Diameter
Total Weight
Mirror Ball Motor
Power Supply
Power Consumption
Rotation Speed
Dimensions
Total Weight
Maximum diameter of mirror ball
Maximum load
The information in this manual is subject to change without prior notice.
VDLPROM2_v2
max. 230VAC/50Hz
max. 30W
∅ 120 x 160mm
1,1kg
PAR-36 lamp [order code LAMP36, LAMP36GE (General Electric)]
45°C
100°C
20 cm (8")
0,980kg
max. 230VAC/50Hz
max. 4W
3 RPM
∅ 110 x 45mm
0,300kg
30cm (12")
10kg
5
VELLEMAN