Rear Panel; Installing The Dedicated Software; Installing The Windows Dedicated Software - Tascam US-2x2 Bedienungsanleitung

Rear panel

US-4x4 rear panel
e
e LINE OUT (BALANCED) jacks
These standard TRS jacks are analog line outputs.
The signals output from the LINE OUT 1–2 jacks
(1–4 jacks on US-4x4) can be set in the Settings
Panel. See "3 Line Outputs items" in the "Settings
page" section of "6 – Using the Settings Panel" in
the Reference Manual for details.
r MIDI OUT connector
This 5-pin DIN is a standard MIDI output
connector.
This outputs MIDI signals.

Installing the dedicated software

To use this unit, a dedicated software must be
installed on a computer.
Download the latest dedicated software for the
operating system you are using from the TEAC Global
Site (http://teac-global.com/).
i On a Windows computer, this will install the
Windows driver and Settings Panel application.
i Installing the dedicated software on a Mac will
install only the Mac Settings Panel application.
The standard OS driver will be used.
i With an iOS device, the standard OS driver will be
used, so there is no need to install any .
CAUTION
Before starting to install software, quit other
applications.
r t y i
US-2x2 rear panel
e
t MIDI IN connector
This 5-pin DIN is a standard MIDI input connector.
Use this to input MIDI signals.
y USB port
Use the included USB cable to connect the unit to
a computer or an iOS device. (Supports USB 2.0.)
u DC IN 5V connector (US-2x2 only)
To use this unit when connected to an iOS device,
connect an external power supply device here.
See "Connecting the power" on page 10 for
details.
i DC IN 12V connector (US-4x4 only)
Connect the included DC12V AC adapter
(PS-P1220E) here.
Installing the Windows dedicated
software
Follow the procedures below to install the Windows
dedicated software.
CAUTION
• Complete installation of the Windows dedicated
software on the computer before connecting the
unit to it with the USB cable.
• If you connected the unit to the computer using the
USB cable before installing the Windows dedicated
software and the "Found New Hardware Wizard"
launched, close the Wizard and disconnect the USB
cable.
8 Windows dedicated software installation
procedures
1. Download the latest Windows dedicated software
for the operating system you are using from the
TEAC Global Site (http://teac-global.com/) and
save it on the computer to be used with the unit.
2. Uncompress the saved software (zip file) on the
computer desktop or another location.
r t y u
TASCAM US-2x2/US-4x4
7