Analog Outputs; Control Input/Output Ratings; Audio Performance; Computer System Requirements - Tascam US-2x2 Bedienungsanleitung

Maximum input level: +20 dBu (7.75 Vrms)
Gain range: 57 dB

Analog outputs

Line outputs (Balanced)
US-2x2: LINE OUT 1-2
US-4x4: LINE OUT 1-4
Connectors: 6.3mm (1/4") standard TRS stereo jacks
(Tip: HOT, Ring: COLD, Sleeve: GND)
Output impedance: 110 Ω
Rated output level: +4 dBu (1.273 Vrms)
Maximum output level: +20 dBu (7.75 Vrms)
Headphones output (PHONES)
Connector: 6.3mm (1/4") standard stereo jack
Maximum output
US-2x2: 18 mW + 18 mW or higher (THD+N 0.1%
or less, into 32 Ω load)
US-4x4: 45 mW + 45 mW or higher (THD+N 0.1%
or less, into 32 Ω load) ( 1 and

Control input/output ratings

MIDI IN connector
Connector: 5-pin DIN
Format: standard MIDI
MIDI OUT connector
Connector: 5-pin DIN
Format: standard MIDI
USB
Connector: 4-pin USB B-type
Transfer rate: USB 2.0 High Speed (480 Mbps)

Audio performance

Mic preamp EIN (equivalent input noise)
−127 dBu or less (150Ω termination with gain knob
at MAX)
Frequency response
IN 1-4 to LINE OUT(BALANCED), PHONES
S/N ratio
101 dB or more (MIC/LINE IN to LINE OUT, gain
knob at MIN, JEITA)
Distortion
2 total)
0.003% or less (MIC/LINE IN to LINE OUT, 1 kHz sine
wave, Rated input level, maximum output level,
JEITA)
Crosstalk
95 dB or more (MIC/LINE IN w LINE OUT, 1kHz,
JEITA)

Computer system requirements

Check the TEAC Global Site (http://teac-global.
com/) for the latest information about supported
operating systems.

Windows

Supported operating systems
Windows 10 32-bit
Windows 10 64-bit
Windows 8.1 32-bit
Windows 8.1 64-bit
Windows 7 32-bit SP1 or later
Windows 7 64-bit SP1 or later
(Windows 8, Windows Vista and Windows XP are
not supported)
Computer hardware requirements
Windows computer with a USB 2.0 port
CPU/processor speed
2 GHz or faster dual core processor (x86)
Memory
2 GB or more
44.1 kHz, 48 kHz
20 Hz : +0 dB/−0.3 dB (JEITA)
20 kHz : +0 dB/−0.1 dB (JEITA)
20 kHz : +0 dB/−0.5 dB (PHONES output, JEITA)
88.2 kHz, 96 kHz
20 Hz : +0 dB/−0.3 dB (JEITA)
40 kHz : +0 dB/−0.2 dB (JEITA)
40 kHz : +0 dB/−2.0 dB (PHONESoutput, JEITA)
TASCAM US-2x2/US-4x4
15