Connecting The Power - Tascam US-2x2 Bedienungsanleitung

Connecting the power

US-4x4
Use the included 12V AC adapter (PS-P1220E) to
connect a power supply to the unit as shown below.
The AC adapter for the US-4x4 includes two types of
outlet plugs. Attach the type of plug that matches the
power outlet that you are using. Please see "Changing
the outlet plug" in the Reference Manual for instruc-
tions about how to do this.
Power outlet
PS-P1220E (included)
8 Changing the outlet plug (US-4x4 only)
1
1 Move the latch on the AC adapter in the
direction of the arrow.
2 Pull off the outlet plug.
3 Replace it with the other outlet plug (A or B).
4 Move the latch on the AC adapter in the
direction of the arrow again.
5 Attach the outlet plug to the AC adapter.
This completes changing the outlet plug.
After changing the outlet plug, confirm that is not
loose or crooked and that everything is normal
before plugging it into an outlet
CAUTION
Do not use the adapter if there is anything
abnormal about the plug after changing it. Use
when the plug is abnormal could cause fire or
electric shock. Contact the retailer where you
purchased the unit or a TEAC service center (see
page 2) to request repair.
10
TASCAM US-2x2/US-4x4
DC plug
3
2
5
4
US-2x2
Normally, when a US-2x2 is connected to a computer,
it will operate using USB bus power, so a separate
power supply is not necessary. To power this unit
when it is connected to an iOS device, however,
you must connect a TASCAM PS-P520E AC adapter,
TASCAM BP-6AA external battery pack or other power
supply device to the DC IN 5V connector. In this
case, connect the power source to the unit as shown
below.
TASCAM PS-P520E
or BP-6AA
CAUTION
• Always use the included PS-P1220E AC adapter
with the US-4x4.
• We highly recommend using a PS-P520E AC
adapter or BP-6AA battery pack (both sold
separately) with the US-2x2. When using another
external power supply device, use one with the
following specifications.
• Power supply voltage: 5 V
• Power supply current: 700 mA or more
Using a power supply device with specifications
other than the above could cause malfunction,
overheating, fire or other problems. If trouble
should occur, stop using the unit and contact the
retailer where you purchased it or a TEAC service
center to request repair.
Power outlet
DC plug