Safety Instructions; User Manual - Velleman VTSSC40N Bedienungsanleitung

1. Introduction + Description
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could
harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it
should be taken to a specialized company for recycling. This device should be returned to your
distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Velleman! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, do not install or use it and contact your dealer.
This soldering station features a temperature control (150°C to 450°C) and a digital temperature display which
displays the set temperature and the actual temperature simultaneously.
The VTSSC40N is a 48W soldering station with a temperature sensor in the ceramic heating element. The
heating element is supplied with the necessary power via a safe 24V transformer, while the bit is completely
isolated from the mains. In case of malfunction, a warning will be displayed on the LCD and the device will emit
a sound.
 This device can be used by children aged from 8 years and above, and persons with reduced
physical, sensory or mental capabilities or lack of experience and knowledge if they have
been given supervision or instruction concerning the use of the device in a safe way and
understand the hazards involved. Children shall not play with the device. Cleaning and user
maintenance shall not be made by children without supervision.
 If the supply cord is damaged, it must be replaced by the manufacturer, its service agent, or
similarly qualified persons in order to avoid any hazard.
Standard bit
Replacement soldering iron
Spare bit
Power supply
Dimensions
Weight
Environmental conditions
2.

Safety Instructions

Warning: this tool must be placed on its stand when not in use; do not leave the tool
unattended when switched on.
 Incorrect use of this tool may cause fire.
 Be cautious when using this tool in places where inflammable products are stored.
 Heat can cause fire to inflammable products even when they are not in sight.
 Do not use the tool in an explosive atmosphere.
 Place the tool back in its stand in order to let it cool down before storage.
3. Operating Instructions
1. Verify whether the mains voltage is compatible with the operating voltage of the device before plugging
it in.
2. Make sure that the device was not damaged in transit.
V. 05 – 13/07/2017
VTSSC40N

USER MANUAL

1
2
3
4
5
6
7
at the rear: fuse holder (250V/1A 5x20mm: FF1N)
BITC10N1
VTSSC40N/SP
BITC10N2, BITC10N3, BITC10N4
220-240 V~, 50 Hz
185 x 100 x 170mm
1.58kg
+5><+40°C; RH<85%
2
LCD temperature read-out (display precision:
5%)
temperature control
iron stand
sponge tray
soldering iron connection
ON/OFF switch
soldering iron
©Velleman nv