Picture Format; Connecting A Video Recorder Device And A Digital Satellite Receiver - Oki B32APH Bedienungsanleitung

9.2.3-PC Setting
Enter into the SETUP menu from the Main
Menu by pressing the MENU button in the
PC mode. In order to make the necessary
settings in this menu, you can use the
right-left, up-down movement buttons
on your remote control. You can make the
following settings for your monitor in this
menu.
9.2.4-HORIZONTAL POSITION:
Horizontal position setting
9.2.5-VERTICAL POSITION: Vertical
position setting
9.2.6-CLOCK
This is the pixel clock frequency. User can
narrow down or enlarge the display by
selecting a desired value.
9.2.7-PHASE
Using the right/left movement buttons,
you can ensure that the colors and shapes
are exactly consolidated on the PC image.
9.2.8-AUTOCONFIGURATION
The most suitable geometric settings
in accordance with the entry mode
are configured by this function.
For this operation, select the
AUTOCONFIGURATION tab and press
OK button. You can adjust the volume
level of the source you have connected to
the Audio-In input at the back of your TV
by using the VOL+/VOL- buttons.
9.3-Connecting a video recorder device and a digital satellite
receiver
Ant In
Ant Out
Scart 1 TV In/Out
Digital Satellite Receiver
Ant In
Scart 2 VCR (AUX)

9.2.9-PICTURE FORMAT

You can select the PC image to be
displayed in 16:9, 14:9 or 4:3 formats.
Note 1: 4:3, 16:9 and 14:9 picture
formats are supported in 16:9 panels.
Only 4:3 picture format is supported in 4:3
panels.
Note 2: In the Monitor mode, you
can make the Brightness, Contrast,
Sharpness, Red, Green and Blue Settings
from the PICTURE menu.
Switching to the HDMI mode
Connect to the HDMI input at the back of
your TV by using the connector located on
your PC or your digital video-transmission
device with a suitable cable (not supplied
with the TV).
Note 1: To be able to watch an image in
the HDMI mode, your computer must be
equipped with a HDMI graphic card.
You may display the resolution information
by pressing the INFO button.
Note 2: Scart1 To connect a RGB-
supported external device to your
television, you must use a Scart cable
supporting RGB. In this case, if your
external device supports, you can set the
output as RGB.
HDCP (Optional)
Your TV supports HDCP feature. To use
this feature, you must set up a connection
to your TV set's HDMI video port and
select HDMI by pressing the AV key on
your remote control.
Ant Out
SCART Socket
Video Recorder
25 I
GB
Ant In
Rear of the Television