Operation - Gardol GAM-E40Li Originalbetriebsanleitung

If the battery fails to charge, please check
•
whether there is voltage at the socket outlet
•
whether there is good contact at the charging
contacts of the charging unit
If the battery still fails to charge, send
•
the charging unit
•
and the screwdriver
to our customer service center.
To ensure that the battery pack provides long ser-
vice you should take care to recharge it promptly.
Recharging is always necessary when you notice
a drop in the performance of your cordless grass
lawn mower.
Never fully discharge the battery pack. This will
cause it to develop a defect.
Fitting the battery pack (Fig. 9)
Swing up the battery cover (E) on the lawn
mower. Push the charged battery pack into the
mount until you hear it latch into place. Close the
battery cover (E).
Removing the battery pack (Fig. 10)
Swing up the battery cover (E) on the lawn mo-
wer. Press the two pushlock buttons (D) on the
side and pull the battery pack out of the charging
unit. Close the battery cover (E).
Battery capacity indicator (Fig. 11)
Press the button (F). The battery capacity indica-
tor will show the charge status of the battery pack
using 4 LEDs.
All 4 LEDs are lit:
The battery pack is charged.
3 LEDs are lit:
The battery pack has an adequate remaining
charge.
2 LEDs are lit:
Stop working and charge the battery.
1 LED is lit:
The battery is empty, recharge the battery.
Anl_GAM_E_40_Li_SPK7.indb 22 Anl_GAM_E_40_Li_SPK7.indb 22
GB

6. Operation

Caution!
The lawn mover is equipped with a safety circuit
to prevent unauthorized use. Directly before star-
ting up the lawn mover insert the safety plug (Fig.
12/Item 15) and remove the safety plug again
whenever you interrupt or terminate your work.
2-step safety lock-off
To prevent the lawn mower from switching on
accidentally, it is equipped with a 2-step safety
lock-off (Fig. 12/Item H) which must be pressed
before the switching bar (Fig. 12/Item K) can be
activated.
The lawn mower will switch itself off when the
switching bar is released completely. Both steps
of the safety lock-off are now activated and you
must press the safety lock-off (Fig. 12 / Item H) in
order to put the lawn mower back into operation.
If the switching bar is released by only a few cen-
timeters, the lawn mower will switch itself off and
it can be put into operation again without the sa-
fety lock-off being pressed (1st step of the safety
lock-off activated). This is used mainly when you
want to interrupt your work briefl y without leaving
the lawn mower.
Repeat this process several times so that you are
sure that the machine functions properly.
Operation electronics (Fig. 13)
The operation electronics (L) can be turned
upwards and downwards through 40°. Turn the
operation electronics so that you can look direct-
ly onto the indicator. The operation electronics
works only when the battery and safety switch are
inserted.
a) Battery capacity indicator
Press the button „M". The battery capacity indica-
tor will show the charge status of the battery pack
using 4 LEDs.
•
All 4 LEDs are lit: The battery pack is char-
ged.
•
3 LEDs are lit: The battery pack has an ade-
quate remaining charge.
•
2 LEDs are lit: Stop working and charge the
battery.
•
1 LED is lit: The battery is empty, recharge the
battery.
- 22 -
28.10.14 09:21 28.10.14 09:21