Service - Clearaudio Cocept Bedienungsanleitung

concept
pic. to no. 4
Adjustment of the Anti-skating force
Again, as everything on the turntable is pre-assembled and tested,
including tonearm and cartridge, there is usually no need to change
concept
any of the turntable parameters. If you want to change your
cartridge and to adjust the Anti-skating force please refer to your
nearest qualified dealer or service personnel. Your dealer will find the
Anti-skating adjuster on the underside of the turntable.
Again, Clearaudio assumes no liability for incorrect handling or any damage caused if non-qualified
persons attempt the above adjustments.
pic. to no. 4
IMPORTANT:

concept
For any transportation of the turntable, please ensure that
the platter is packed with the upper surface facing downwards into
the packaging. Please also ensure that you fully retract the turntable
feet.
Further transportation advice:
pic. to no. 4
concept
For any transportation of the turntable, please always
remove the turntable platter (see above) and fix the tape holding the
sub-platter as well as the tonearm and the cartridge stylus
protection. Otherwise serious damage can occur.
Clearaudio assumes no liability for any damage that may occur due to incorrect packing.

5. Service

If any servicing or repair on a Clearaudio product is necessary, please contact your dealer / distributor or
contact Clearaudio directly. We can advise you of your nearest service location.
PLEASE RETAIN ALL ORIGINAL PACKAGING. You will need it if your turntable needs to be transported and/or
shipped. Any further questions you may have about this turntable should be directed to your dealer /
distributor or directly to Clearaudio at:
Clearaudio electronic GmbH
www.clearaudio.de
Spardorfer Straße 150 www.analogshop.de
91054 Erlangen info@clearaudio.de
Germany
Phone: +49 9131 40300 100 Fax: +49 9131 40300 119
7