Storch Color Free Bedienungsanleitung Seite 57

The system returns to its home position and the following
appears in the display:
For further cleaning you can remove the filter strainer
holder and also the grip bar. Then fold the filter pipe back
into normal position, connect it to the drain using the
discharge hose with the elbow joint. Keep the spray head
at hand.
Then press S1
Display:
Press S3
Display:
The agitator pump starts and the following appears in the
display:
Now thoroughly spray the reaction container, pump and
piping clean; the water used here is routed directly to the
grey water drains with the residual soiling. After fully
pumping off the water,
8.1.1 Optional retroactive admixing
If the water is still cloudy after the reaction time "t" expires, you must add more separating agent and continue the
reaction. As described previously, the following appears in the display:
Press S3
The following appears in the display:
These two displays toggle for a period of one minute, and you are prompted to add more separating agent. Add a sepa-
rating agent dose appropriate to the residual cloudiness of the water, adding it to the water as described for normal
operation. The following again appears in the display:
The reaction time of 1 minute now runs automatically; then the following appears in the display:
If the water sample is subsequently clear, the normal mode will run with the 2 minute settling time and then the dis-
play „Filtration S1" will appear. If the water sample is still not satisfactory, repeat the „Additional dosing" process and
press S3.
STORCH ColorFree
Start button S1
Filling S1
Pump out S3
Please wait
Flushing
Stop button S1
Settling time 2 min.
Retroactive admixing S3
Reaction
Pause button S2
Reaction t = 1 min
Pause button S2
Settling time 2 min.
Retroactive admixing S3
press S1
Display:
then:
Press S1
The system returns to its home position,
the following appears in the display
Then remove the discharge hose and re-insert the grip
bar. After inserting the filter strainer holder and the filter
strainer with a new filter bag, the system is ready for use
again.
Cleaning procedure
Separating agent
Addition / Retroactive admixing
57
Please wait
Pause button S2
Filtrate removal
Stop button S1
STORCH ColorFree
Start button S1
Translation of the original instruction