HEYLO DT 750 Bedienungsanleitung Seite 19

Connection of the drain hose
TANK
Service flap
At the connection of the tank, a 3/4 in. drain hose can be connected which automatically drains water
from the tank through a gradient.
Additional functions: Use of a condensate pump
When an optional condensate pump is used, this has to be installed in the tank and the pump
connected has to be fitted in the tank room.
Proceed as follows:
1. Remove condensate tank
2. Plug in the plug for condensate pump
3. Place the pump in the unit
4. Close the flap and place the condensate hose to the outside in a water drain
5. Set the electronics to operation with condensate pump
To activate the pumping function press the buttons 5 and 3 at the same time until the Tank FULL
display E lights up briefly. The display reads PUMP. The pump is active now; the display FULL flashes
every ten seconds.
add (1) add (2)
19
add (3)
EN