Closing The Door; Installation; Replacing The Lamp - Electrolux IK2755BL Benutzerinformation

Problem
The temperature in the ap-
pliance is too low/too high.

7.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to

"Installation".

3. If necessary, replace the defective
door gaskets. Contact the After Sales
Service.
8. INSTALLATION
8.1 Positioning
This appliance can be installed in a dry,
well ventilated indoor where the ambient
temperature corresponds to the climate
class indicated on the rating plate of the
appliance:
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Possible cause
The temperature regulator
is not set correctly.
The door is not closed
correctly.
The food products' tem-
perature is too high.
Many food products are
stored at the same time.
The thickness of the frost
is greater than 4-5 mm.
The door has been
opened often.
The ActionFreeze function
is switched on.
The Shopping Function
function is switched on.
There is no cold air circu-
lation in the appliance.

7.3 Replacing the lamp

The appliance is equipped with a longlife
LED interior light.
Only service is allowed to replace the
lighting device. Contact your After Sales
Service.
Climate
class
SN
N
ST
ENGLISH
Solution
Set a higher/lower tempera-
ture.
Refer to "Closing the door".
Let the food products tem-
perature decrease to room
temperature before storage.
Store less food products at
the same time.
Defrost the appliance.
Open the door only if neces-
sary.
Refer to "ActionFreeze func-
tion".
Refer to "Shopping Function
function".
Make sure that there is cold
air circulation in the appli-
ance.
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
15