Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Allgemeiner Teil / General Section
Factory Settings
Factory Defaults
Remove All Services
Remote Control
Factory Settings
Factory Defaults
Remove All Services
Remote Control
20
21
19
1 - 20
IMPORTANT INFORMATION
5
Select the »Factory Defaults« row using the
with »OK«.
– A dialogue box appears on the picture screen.
SAT 1
6
If not yet done, select the »Yes« option using the
confirm with »OK«.
– The satellite receiver is reset to the factory settings and these are auto-
matically saved.
Exit
Back
Select the »Remove All Services« row using the
7
confirm with »OK«.
– A dialogue box appears on the picture screen.
8
If not yet done, select the »Yes« option using the
confirm with »OK«.
– All changed settings of the satellite receiver are cancelled.
Note:
If you want to control two satellite receivers
remote control TP 760 S, you must select for one satellite receiver a different
remote control code.
9
Select the »Remote Control« row using the
confirm with »OK«.
– A dialogue box appears on the picture screen.
SAT 1
10
Select the appropriate option, e.g. »SAT2«, using the
confirm with »OK«.
– This satellite receiver then is controlled with the » SAT2 « remote control
code, the other satellite receiver with the » SAT1 « remote control code
Exit
Back
(= factory setting).
11
Press »Z« to return to the »System Setup« menu, or
press »
TECHNICAL DATA
Pin assignment of the EURO-AV sockets
If you want to connect additional units (e. g. video recorder, decoder) to your
SAT receiver, your specialist dealer will be able to create a standard connection
using the following connection table.
Contact
01
=
2
02
=
03
=
04
=
05
=
1
06
=
07
=
08
=
09
=
10
=
11
=
12
=
13
=
14
=
15
=
16
=
17
=
18
=
19
=
20
=
21
=
x = connected
x
)
switching voltage only in »SAT« mode.
1
Subject to technical alterations and errors.
___________________________________________________
»P+, P-
« buttons then confirm
»P+, P-
»P+, P-
»P+, P-
DTR 61xx
»P+, P-
»P+, P-
« to end the settings.
Menu
______________________________________________________________________
Signal
TV
VCR
Audio output, right
x
x
Audio input, right
x
Audio output, left
x
x
Audio earth
x
x
Blue earth
x
x
Audio input, left
x
RGB blue
x
Switching voltage
x
x
1
)
1
Green earth
x
x
–
RGB green
x
x
–
Red earth
Earth
RGB red input, (S-Video = chrominance)
RGB switching voltage
Video earth
RGB switching voltage earth
Video output
Video input, (S-Videoo = luminance)
Screen/earth
Sinio DTR 6110 S / 6111 S CI
« buttons then
« buttons then
« buttons then
with only one
« buttons then
« buttons then
67
)
71
GRUNDIG Service
Werbung
Inhaltsverzeichnis
