Unpacking - AEG LAVATHERM 75280AC Benutzerinformation

48
• The temperature of the hot
• When the tumble dryer oper-
• If it is necessary to move the
• The appliance must not be in-
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
15mm

UNPACKING

CAUTION!
Before use all parts of the transport
packaging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
air which occurs in the tumble
dryer can increase to 60 °C.
The appliance must not be in-
stalled on the floor which is
not resistant to high tempera-
tures.
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
appliance, it must be moved
vertically.
stalled behind a lockable
door, a sliding door, a door
with a hinge on the opposite
side to that of the appliance
in such a way that a full open-
ing of the tumble dryer is re-
stricted.
2. Pull 2 plastic hoses with the poly-
styrene blockages out from the
drum.
INSTALLATION UNDER A
COUNTER
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
600 mm
600 mm
> 850 mm
THE LOAD DOOR REVERSAL
The load door can be installed by the
user in the opposite side if there is a
limit to install the appliance. (see sepa-
rate leaflet).
x2