Installation; Appliance Positioning; Unpacking - AEG LAVATHERM 86589IH2 Benutzerinformation

48 www.aeg.com

12. INSTALLATION

12.1 Appliance positioning

• The tumble dryer must be installed in
a clean position, where dirt does not
collect.
• Air must flow freely around the appli-
ance. Make sure that the front airflow
slots in the bottom of the appliance
are not blocked .
• To keep vibration and noise at the
minimum, when the tumble dryer op-
erates, it must be put on a stable and
flat surface.
• When the appliance is put in its per-
manent position, check if is fully level
with the aid of a spirit level. If it is not,
adjust the feet until it is.
• Do not remove the feet. Do not de-
crease the floor clearance through
thick carpets, bar of wood or equiva-
lent. This can increase the heat which
can cause interference with the opera-
tion of the appliance.
• The temperature of the hot air
• When the tumble dryer oper-
• If it is necessary to move the
• The appliance must not be in-

12.2 Unpacking

CAUTION!
which occurs in the tumble dry-
er can increase to 60 °C. The
appliance must not be instal-
led on the floor which is not re-
sistant to high temperatures.
ates, the room temperature
must not be lower than +5 °C
and higher than +35 °C. This
can cause unwanted effect on
the performance of the appli-
ance.
appliance, it must be moved
vertically.
stalled behind a lockable door,
a sliding door, a door with a
hinge on the opposite side to
that of the appliance in such a
way that a full opening of the
tumble dryer is restricted.
Before use all parts of the transport
packaging must be removed.
To remove the polystyrene blockages:
1. Open the load door.
2. Pull plastic hose with the polystyrene
blockages out from the drum.
It is possible to adjust the height of the
tumble dryer. To do that adjust the feet
(see picture).
15mm
12.3 Installation under a
counter
The appliance can be installed as free-
standing or below the kitchen counter
with correct space (see picture).
600 mm
600 mm
> 850 mm