HQ Power VDPL300HD Bedienungsanleitung Seite 3

4. Features
•
multi-coloured effect to cover complete room
• DMX controlled by 8 channels
• auto mode, sound activated or master/slave mode
• built-in microphone for sound activation
5. Overview
1
6 5 4
6. Installation
a. Mounting the Device
• Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
• The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
• The installation must always be secured with a secondary attachment e.g. a safety cable.
• Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
• Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
• Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
• Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
• Make sure there is no flammable material within a 0.5m radius of the device.
• Have a qualified electrician carry out the electric connection.
• Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The installation has to be approved by an expert before the device is taken into service.
b. Fuse Replacement
Only fit or replace a fuse when the device is unplugged from the mains.
Replace a blown fuse with a fuse of the same type and rating (see "Technical Specifications"):
1. Remove the fuse holder using a flat-head screwdriver.
2. Remove the old fuse and install a new one.
3. Put back the fuse holder.
7. Operation
The device can be used in the following modes:
• Standalone mode (with the built-in microphone)
• Master-slave
• With a DMX512 controller
V. 01 – 10/04/2012
VDPL300HD
2
3
1 LED display
2 DMX input
3 DMX output
4 Built-in microphone
5 Fuse holder
6 IEC cord input
3 ©Velleman nv