Lenz Digital plus LS100 Information Seite 27

Connecting the switching devices
1
1
Connection of double-coil point drives (1)
Connect the common connection of the two coils (2) to terminal "C", the cable of
coil 1 (1) to terminal "+", and the cable of coil 2 (3) to terminal "-". Depending on
the drive used, enabling output "+" results e.g. in the point setting "Branch". If this
is not what you want, simply swap the connections at the terminals "+" and "-".
The following table contains the most common colour codes of a series of
manufacturers, with reference to the numbering of the cables in the illustration
above.
2
2 3
+ +
C C
RM RM RM RM
1 2
J K R S Lenz Elektronik GmbH D 35398 Giessen
Figure 5
3 4
R
LA010
+ +
C C
RM RM RM RM
3 4
27
E