Werbung
Setting Locomotive Parameters with the
Control Unit
1. Requirement: Setup as in diagram on page 24. Only the
locomotive to be changed can be on the track.
2. Press the "Stop" and "Go" at the same time until "99"
blinks in the display.
3. Press the "Stop" button.
4. Enter the locomotive address „80".
5. Hold the control knob in the reverse direction area. While
holding the control knob here, press the „Go" button.
6. The headlights on the locomotive will blink slowly. If they
don't, repeat Step 2.
7. Enter the register number for the parameter to be changed
(=> List on page 26).
8. Active the change of direction.
9. The headlights will blink rapidly.
10. Enter the new value (=>List on page 26).
11. Active the change of direction.
12. The headlights will blink slowly (exception: factory reset)
13. Enter the next parameter setting from 6 or end with 14.
14. End the process by pressing the „Stop" button. Then press
the „Go" button.
Central Station/Mobile Station: see the description for the
unit in question.
Changes to the locomotive parameters in the decoder may only
be carried out as described. Märklin is not liable for changes
beyond this that cause malfunctions or damages to the decoder;
the cost for any necessary repairs must be borne by the
consumer.
11
Werbung
