Kerbl 1085 Bedienungsanweisung Seite 27

Example of how to use the looping mode
automatically get supervision of two cameras without manually changing the channel. LED indicators on AVLink will display which channel is
AVLink. However, the processing possibility depends on local conditions and possible sources of interference.
A/V connection with your TV
For further instruction see your TV manual. The receipt on TV does not influence the video signal to the wireless LCD monitor.
The following antennas are included in your StableCam™-solution
and should be used in the following places:
The black camera antenna should be attached to the camera when adjusting the
camera angle during installation in the stable. Before you start your installation, start
antenna cable. It transmits signal with full strength in the direction the antenna is
pointed to!
your house with the included 5 meter antenna cable.
The transmitting AVLink antenna is connected to the transmitting part of the AVLink.
This antenna makes sure that you get better picture quality inside your house.
CABLES
27