Operating The Tool - Stinger CS150ST Bedienungsanleitung

www.stingerworld.com

OPERATING THE TOOL

1.! Do not use tool prior to reading the STINGER CS150ST Owner's Manual.
2.! Read warning label(s) on the tool.
3.! Visually inspect the tool for worn or damaged parts.
4.! Wear appropriate eye and ear protection.
5.! Install a male pneumatic fitting into the End Cap of the tool, ensuring that the fitting allows
the tool to exhaust any air in the tool when the air hose is disconnected.
6.! Add 2 drops of non-detergent, 20-weight oil into the male fitting daily.
7.! Connect the air hose to the tool using a quick connect fitting, and check the air pressure reading on the
regulator to ensure it does not exceed 110PSI. Check the tool for any air leaks.
8.! Place the tool, empty of fasteners, in operating position on a scrap work piece. Fully depress the Safety and
pull the Trigger to verify that the tool cycles.
9.! Disconnect the air hose from the tool when:
•! Loading staples and/or caps
•! Performing inspection, maintenance or repair
•! Clearing a staple or collated cap jam
•! The tool is not in use
•! Leaving the work area
•! Moving the tool to another work location
•! Handing the STINGER CS150ST to another person
•! Storing the tool
10.! Following recommended loading instructions, load the fasteners approved for use in the tool. See Page 6.
11.! Cycle the tool on a scrap work piece to evaluate the depth of penetration by the fastener into the work piece.
12.! To adjust the depth of penetration, regulate the air pressure at the regulator and/or disconnect the air hose,
adjust the depth control screw, connect the air hose, and cycle the tool on a scrap work piece to evaluate the
adjustment.
13.! Repeat Step 12 as needed to set the correct depth, using the minimum amount of air pressure to drive the
fastener.
CS150ST Cap Stapler CS150ST
6