Troubleshooting - Stinger CS150ST Bedienungsanleitung

www.stingerworld.com

TROUBLESHOOTING

Disconnect the air hose from the tool when performing inspections, maintenance or repairs.
PROBLEM:
1.! Tool operates, but no fasteners are
driven.
2.! Cap leaks air.
3.! Fasteners jam in nose of tool.
4.! Weak drive.
5.! Skipping fasteners.
6.! Fasteners will not drive completely into
work piece.
Please contact Inside Sales for technical support if you have any other problems: 800-746-5659
11
CORRECTION:
•! Check Magazine for proper fasteners. Fasteners
should slide freely in and out of the magazine.
•! Tighten cap screws.
•! Remove fasteners from Magazine.
•! Open Quick-Clear™ Lever (if applicable), remove
jammed fastener and close Latch.
•! Load tool.
•! Check to make sure there is adequate air supply.
•! Replace Bumper if worn.
•! Use only recommended fastener sizes.
•! Replace Magazine if worn.
•! Check air supply as it may be too low or too high.
•! Adjust the depth of drive.
CS150ST Cap Stapler CS150ST