Tool Specifications - Stinger CS150ST Bedienungsanleitung

www.stingerworld.com

TOOL SPECIFICATIONS

Operating pressure
Weight
Staple capacity
Cap capacity
Air inlet
Fasteners
Lubrication
Audio Data
Vibration Data
3
95-105 psi (6, 5-7,5 bar)
4.2lbs / 1.9kg
200 staples (2-100 count strips)
200 plastic collated caps (1 reel)
3/8 NPT
7/8"/22.1mm, 1-1/4"/31.75mm, or 1-1/2"/38.1mm STINGER StaplePac
fasteners or STINGER Collated Plastic Caps (10 reels of 25.4mm diameter plastic
collated caps - 200 caps per reel) with 15mm AERFAST
staples per strip).
Add 2 drops of non-detergent, 20-weight oil into the male fitting daily.
Loudness levels presented in the table below are in accordance with EN 792-13
(EN12549+A1:2008)
L pA 1s,1m = 86,7 dB(A)
L wA 1s = 99,7 dB(A)
L pA 1s, = 90,7 dB(A)
These levels are characteristic of the tool but does not represent the sound that
occurs at the point the tool is used. Workstation design can reduce the noise levels,
for example by placing the work piece on sound absorbent supports.
This value is in accordance with EN 792-13 (ISO 8662-11:1999)
Equivalent Vibration Value = a
This value is characteristic of the tool and does not represent the effect of the hand-
arm system when using the tool.
(m/s 2 ) = 3,3
hv,eq
CS150ST Cap Stapler CS150ST
cap
®
® aluminum staples (100