OHAUS Valor 4000W Bedienungsanleitung Seite 13

Valor™ 4000W Series
4.5 Mode Menu
Enter this menu to activate modes so they will be available for use with the Mode
button. Weigh mode is always active by default.

Reset [reset]
Reset the Mode menu to factory defaults.

Percent [PerCNt]
Set the status.

Check [CHECk]
Set the sub-mode.

End Mode [End]
Advance to the next menu or return to the top of the current menu.
4.6 Unit Menu
Enter this menu to activate units so they will be accessible with the Units button.
The units in the menu must be turned "on" to be active.
Note: Available units vary by model and local regulations.
4.7 Lock Menu
The Lock Menu is a software controlled option which can lock Menu settings to
prevent tampering.

Reset [reset]
Reset the Lock menu to factory defaults.

Lock Cal [l.CAL]
Set the status.

Lock Setup [l.SEtUP]
Set the status.

Lock Read [l.rEAD]
Set the status.

Lock Mode [l.mMOdE]
Set the status.

Lock Unit [l.UNIt]
Set the status.

End Lock [End]
Advance to the next menu or return to the top of the current menu.
4.8 End Menu
Press 'Yes' to advance to the Calibration menu. Press 'No' to exit the menu and
return to the current application mode.
(no, yes)
(off, on)
(off, on)
(no, yes)
(off, on)
(off, on)
(off, on)
(off, on)
(off, on)
EN-11