Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Installation
The winch shown in this owners manual is solely and
exclusively designed for vehicle mounted, non-industrial
applications. All other applications will void warranty.
It is very important that the winch be mounted on a flat
surface so that the three major sections (the motor end,
the cable drum, and the gear housing end) are properly
aligned. It is recommended that Ramsey kits be used to
mount the winch. They are designed to align the winch
and distribute up to the full rated load evenly, to avoid
possible damage to the winch or vehicle.
NOTE: If recommended mounting is not used, a kit of
equal design must be used.
CONTROL SWITCH
RECEPTACLE
CONNECT BLACK GROUND CABLE
TO NEGATIVE (-) TERMINAL
OF VEHICLE BATTERY.
CONNECT RED CABLE
TO POSITIVE (+) TERMINAL
OF VEHICLE BATTERY.
ROLLER FAIRLEAD
(CAUTION DECAL ON TOP)
ROLL PIN
CABLE HOOK
CLEVIS PIN
FAIRLEAD MOUNTING HARDWARE
TWO 7/16-14NC X 1.25 LG BOLTS
TWO 7/16 LOCK WASHERS & TWO 7/16-14NC NUTS
IN THE TOP 1/2" DIA. HOLES OF FAIRLEAD
FIGURE 1
4
Attach fairlead to channel using hardware furnished with
winch.
NOTE: To ensure proper alignment of roller fairlead to
winch, position larger (1/2") holes at top.
Attach winch to channel. Thread capscrews with
lockwashers through mounting holes in channel and into
winch feet (see FIGURE 1).
Substitution of attaching hardware items (bolts, nuts or
washers) different from those supplied with your winch
and mounting kit can lead to failure causing damage or
serious injury (use SAE grade 5 bolts or better and
torque to 44 ft.lbs.).
CLUTCH HANDLE
WINCH MOUNTING HARDWARE
FOUR 7/16-14NC X 1.00 LG. BOLTS
FOUR 7/16 LOCK WASHERS
FOUR 7/16 FLAT WASHERS
MOUNTING CHANNEL
Werbung
Kapitel
Inhaltsverzeichnis
Fehlerbehebung
