Philips HB568 Bedienungsanleitung Seite 7

4 When you are lying on the couch, pull the canopy into a horizontal position (fig. 26).
5 When the set tanning time has elapsed, the lamps will be automatically switched off.
After the facial tanner has been switched off, you have to wait 3 minutes before you can switch the facial tanner back on. During this cool-down
period the symbols near the •/º button will blink.
You can switch the facial tanner on or off during the session by pressing the ª button (fig. 29).
Press the •/º button to switch between full intensity and half intensity (fig. 29).
During the tanning session, you can switch the body cooling on for extra comfort by pressing the ≠ button (fig. 29).
Natural fragrances (HB568 only)
During tanning or relaxing you can enjoy your favourite fragrance.You can choose from three different fragrances.
The scent granules have been specially developed for use in this appliance. Do not use other granules.
Filling the cartridge
1 Remove the cap of the cartridge by pulling while applying pressure in the small pressing points (fig. 30).
2 Open the sachet at the small opening at the top.
3 Fill the cartridge with the content of one whole package of scent granules.
4 Close the cartridge by putting the cap back onto it.You will hear a click.
Placing or removing the cartridge
1 Place the cartridge in the holder. It only fits in one way and locks in place with a click (fig. 31).
To remove the cartridge, place your thumb and index finger on the sides of the cartridge. Remove the cartridge from the holder by
pressing on the disc (fig. 32).
Setting the fragrance level
1 You can set the fragrance level by turning the cartridge (fig. 33).
Turn the cartridge in the direction of the large flower symbol to increase the fragrance level and turn it in the opposite direction to reduce the
fragrance level.
2 When you store the appliance or do not want it to emit a fragrance, turn the cartridge away from the large flower symbol as far as it
goes (fig. 34).
The holes will no longer be visible.
3 Replace the granules when the cartridge no longer emits any fragrance. Replacement packages with 3 sachets of scent granules are
available under type number HB080.
Please bear in mind that the fragrance level depends on a number of factors, such as the following:
- Habituation may cause fragrances to be perceived less or not at all, but this is normal.
- When you lie on your belly, the fragrance will be less noticeable than when you are lying on your back.
- Airflows in the room where you use the appliance may also affect the fragrance level.
- Your personal condition may also influence the degree in which you perceive the fragrance.
Stereo Active Speakers (HB567 and HB568 only)
During tanning you can listen to your own favourite music by connecting your own audio player (e.g. CD/MP3 or radio) to the appliance.
To connect your own audio player to the appliance, use the cable with 2 jack plugs supplied with the appliance.
1 Insert one jack plug into the AUX socket on the right side of the speaker.
2 Insert the other jack plug into the headphone socket of your audio player (e.g. CD, MP3 or radio).
You can adjust the volume on your own audio player.
- Do not set the volume extremely high, as this could cause irreparable damage to the speakers.
- In fact, we advise you to set the volume lower than you are accustomed to, because the space between couch and canopy works as an
acoustic box and amplifies sound.
Cleaning
Always unplug the tanning appliance and let it cool down before you start cleaning it.
Never use scouring pads and abrasive liquids such as scouring agents, petrol or acetone to clean the appliance.
Never use liquids such as alcohol, methylated spirits, petrol or acetone to clean the acrylic sheets as this may cause
irreparable damage.
Clean the outside of the tanning appliance with a damp cloth. Do not let any water run into the appliance.
Replacement
The light emitted by the tanning lamps will become less bright in time (i.e. after a few years in case of normal use).When this happens, you will
notice a decrease in the tanning capacity of the appliance.You can solve this problem by setting a slightly longer tanning time or by having the
tanning lamps replaced.
Have the tanning lamps and/or starters replaced by a service centre authorised by Philips.They have the knowledge and skills required
for this job and the original spare parts for your tanning appliance.
If you really insist on replacing the tube lamps and/or starters yourself, you should proceed as follows:
1 First remove the mains plug from the wall socket.
2 Loosen the screws and remove the two end caps (fig. 35).
ENGLISH
7