Changing The Battery Of The Remote Control; Use - EASYmaxx 03888 Anleitung

EN
5. Carefully hang the wall-mounted fi re into the wall bracket from above. Check that it
fi ts securely in the suspension device for the wall bracket (8).
6. Mark out the two drill holes for the short wall bracket.
7. Detach the wall-mounted fi re from the wall bracket again.
8. Drill holes into the wall and place dowels in them.
9. Once again carefully hang the wall-mounted fi re into the wall bracket from above.
Check that it fi ts securely in the suspension device for the wall bracket.
10. Screw the short wall bracket onto the wall. The wall-mounted fi re is now securely
fi xed to the wall.

Changing the Battery of the Remote Control

1. The battery compartment is located on the narrow side of the remote control. Pull it
out as shown (Picture F).
2. Take the used battery out and insert a 3 V battery of the CR2025 type. The positive
pole must be facing upwards.
3. Push the battery compartment back into the remote control to the limit stop.

Use

PLEASE NOTE!
■ Do not cover the device during operation. Do not hang any laundry or similar items
over the device to dry.
■ Warning – Danger of fi re! Do not operate the device unattended so that you can
intervene immediately in the event of any faults.
1. Insert the mains plug into a properly installed plug socket that is easily accessible.
2. Move the On / Off switch (5) to the I (On) position. A beep sounds and the device is
in stand-by mode.
3. Adjust the device as you require using the control panel (9) or the remote control (see
the following chapters).
All settings are shown on the display of the device. The display goes out after
around 30 seconds. Before other settings can be made, the display must be
activated again. To do this, press any button on the control panel or the remote
control.
4. To switch off the device, move the On / Off switch to the O position.
5. Remove the mains plug from the plug socket after use.
22