IDEAL 3915-94 Betriebsanleitung Seite 17

(Messer muß dabei parallel in die Schnitt-
leiste eindringen). Bei Bedarf das Messer
vor dem Herunterfahren mit der Messer-
verstellschraube
g) Hauptschalter in Position I bringen und
bei hochgefahrenem Messer alle 5 Messer-
schrauben fest anziehen. Zur Probe einen
Papierstapel durchschneiden und das Mes-
ser eventuell über die Messerverstell-
schraube nachjustieren.
Achtung: Das Messer ist extrem
scharf!
KNIFE CHANGE
A reduction in cut quality indicates that a
knife change is necessary (as a rule, after 20
cutting hours). This operation has to be
performed by one person only.
a) Turn the knife depth adjustment screw
to the left until it stops (
in tool set).
b) Lower the knife by pressing both cut
buttons. Keep one button pressed and turn
off the main switch
now exposed and should be turned to position
0. Remove the special wrench (
tool set) and turn on the main switch
the knife returns to the home position.
c) Remove the 2 knife screws k
the knife changing tool k
fasten it to the knife. The remaining screws
should then be removed. Loosening the
grips of the knife changing tool k
now allow the knife to be taken downwards
out of the machine.
tiefer stellen.
Screwdriver found
. The eccentrics k
are
a
found in
until
. Then put
b
into place and
c
lightly will
c
d) If needed the cutting stick
turned or exchanged, and should be placed
exactly on the pin (on the left hand side).
e) Place the knife to be exchanged with the
knife changing tool k
knife carrier k
up to the top and screw it into
d
place with the grips. Lightly tighten 3 of the
5 knife screws (with washers), remove the
knife changing tool and lightly tighten the
remaining knife screws (with washers) k
f) Remove all tools and distribute paper
along the entire cutting length. The knife
should again be lowered as described in
point b). The 3 eccentrics k
used to lower the blade until the paper is cut
along the entire length of the knife (The knife
must remain parallel to the cutting stick). If
needed, the knife can be lowered using the
knife depth adjustment screw
be in upper position.
g) Turn main switch
will return to the upper position and the knife
screws should be tightened firmly. Cut a
stack of paper to test; if necessary the knife
can be lowered using the knife depth
adjustment screw
Attention: The knife is extremely
sharp!
- 17 -
can be
mounted, into the
c
b
should then be
a
; knife must
to position I. The knife
.
.