Hilti SF 22-A Bedienungsanleitung Seite 19

3.2 Intended use
The product described is a hand-held cordless drill / driver. It is designed to be used for driving and removing
screws and for drilling in steel, wood and plastic. The "'SFH" model is also suitable for hammer drilling in
masonry.
▶ Use only Hilti Li-ion batteries of the B22 series with this product.
▶ Use only the Hilti battery chargers of the C4/36 series for these batteries.
3.3 Li­ion battery display
The charge status of the Li-ion battery and malfunctions of the power tool are indicated by the display on
the Li­ion battery. The charge status of the Li­ion battery is displayed after pressing one of the two battery
release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Battery charge status cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery display LEDs blink, please observe the instructions given in the Troubleshooting section.
3.4 Items supplied
Drill / driver, side handle, operating instructions.
• Other system products approved for use with this product can be found at your local Hilti Store or online
at: www.hilti.group | USA: www.hilti.com
4 Drill/driver
Rated voltage
Weight in accordance with EPTA procedure 01
Speed
Torque (soft joint)
Torque range (15 settings)
Ø drill bit (softwood)
Ø drill bit (hardwood)
Ø drill bit (metal)
4.1 Noise information and vibration values in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance with
a standardized test and may be used to compare one power tool with another. They may be used for a
preliminary assessment of exposure.
The data given represents the main applications of the power tool. However, if the power tool is used for
different applications, with different accessory tools or is poorly maintained, the data may vary. This may
significantly increase exposure over the total working period.
*362170*
Printed: 24.09.2018 | Doc-Nr: PUB / 5070677 / 000 / 05
1st gear
2nd gear
3rd gear
362170
Meaning
• Charge status: 75 % to 100 %
• Charge status: 50 % to 75 %
• Charge status: 25 % to 50 %
• Charge status: 10 % to 25 %
• Charge status: < 10 %
• The battery has overheated or is completely
discharged.
• The power tool is overloaded or has overheated.
SF 22-A
21.6 V
2.52 kg
0 /min ... 370 /min
0 /min ... 1,250 /min
0 /min ... 2,140 /min
≤ 50 Nm
2 Nm ... 12 Nm
1.5 mm ... 32 mm
1.5 mm ... 20 mm
1.5 mm ... 13 mm
SFH 22-A
21.6 V
2.58 kg
0 /min ... 370 /min
0 /min ... 1,250 /min
0 /min ... 2,140 /min
≤ 50 Nm
2 Nm ... 12 Nm
1.5 mm ... 32 mm
1.5 mm ... 20 mm
1.5 mm ... 13 mm
English 15