Upper And Lower Section - SEAL 62S Betriebsanleitung

5.4.2

Upper and lower section

A release board or a leader panel of the same thickness as the panels to process is
needed.
Figure 18: Upper and lower section webbed.
The film in the upper section is webbed first
1. Remove the image guide.
2. Feed the film underneath (B) the splitter bar (between splitter bar and upper roller)
•
Pressure sensitive film without a release liner must be fed over the splitter bar (A).
3. Pull the film forward until it almost reaches the in-feed table and apply it to the upper
roller.
If the film has a release liner (B):
•
Peel off the release liner,
•
Pull it up and stick it from below onto the cylinder on the wind-up shaft.
Now web the lower section
Figure 19: Webbing lower section.
4. Lift the in-feed table and put it in the upper position (A).
5. Unwind the film from the lower unwind roll.
•
Feed a pressure sensitive film without release liner underneath the splitter bar (A),
•
Feed all other films over the splitter bar (B).
6. Pull the film forward until the end reaches above the nip and stick it to the film from the
upper section.
34 User Manual 62S