Installation And Removal Of The Water Supply Bottle Cap; Installation And Removal Of Water Filter Set (Use Of City Water) - DeguDent Cercon mill Gebrauchsanweisung

3 Installation Procedures of Each Component
Water Supply Bottle
Fig. 7
Water Supply Bottle Cap
Fig. 8
Bleeder Button
Fig. 9
White Ring
Fig. 10
24
Packing
Water Connector
Hose
Water Filter Case
3.4 Installation and Removal of Water Supply Bottle
Removal: Holding the water supply bottle, push in the
bottle attaching/detaching switch until it is locked, and as
it is pushed in, while holding the control unit, pull out the
water supply bottle upward (Fig. 7).
• After use, if water is low in the water sup-
ply bottle, the water supply bottle may
pop out; therefore, the bottle attaching/
detaching switch should be pressed as
the water supply bottle is held.
3.5 Installation and Removal of the Water Supply
Bottle Cap
Installation: Check the packing inside the water supply
bottle cap for misalignment or detachment, and then close
the water supply bottle cap (Fig. 8).
Removal: Before opening the water supply bottle cap, be
sure to press the bleeder button to release the pressure in
the water supply bottle (Fig. 9). Check that the pressure
is completely released, and then open the water supply
bottle cap.
3.6 Installation and Removal of Water Filter Set (Use
of City Water)
Push the hose of the water filter set (the side of the water
filter with a case) into the tap water connector on the back
of the control unit until it is securely set to make connection
as shown in Fig. 10. Check if the hose is securely installed
by slightly tugging it after connection. Connect the other
end of the hose to the tap water line.
• Push the hose of the water filter set into
the tap water connector until it is securely
set. Otherwise, water may leak. Pushing
the white ring, on the water connector,
gently remove the tube.