Weidmuller THM Basic 300 Bedienungsanleitung Seite 46

Operating the Printer
Control panel
The control panel consists of three LEDs and three multi-purpose buttons.
LEDs
The LEDs show the printer status.
READY Illuminated
MEDIA Illuminated
Flashing together with the
READY LED
Flashing
RIBBON Illuminated
Off
Flashing together with the
READY LED
Table 2 LEDs
Multi-purpose buttons
The printer can either be in a normal (ready) state or in a system state.
Normal mode
PAUSE Interrupt the print job
Resume the print job after interruption
FEED Feed in one label
CANCEL Cancel the print job
Continue printing after error has been fixed
Table 3 Multi-purpose buttons
46
Normal status of printer
Normal status of printer
The label roll is finished
PAUSE status
Normal status of printer
Direct thermal print (ribbon is not inserted)
The ribbon roll is finished
System mode
Self-test
Calibrate label sensor
Reset
1168670000/02/08.11