Rear Panel - Tascam Celesonic US-20x20 Bedienungsanleitung

Rear panel

COAXIAL IN jack
w
This digital audio input jack complies with the S/PDIF
standard.
USB port
e
Use the included USB cable to connect the unit to a
computer or iOS device (supports USB 2.0/3.0).
CAUTION
• Which of the included cables (USB 2.0 or USB 3.0) can be
connected depends on the computer and operating system
being used. (See "Connecting with a computer" on page
10.)
• USB 1.1 is not supported.
OPTICAL (S/MUX) IN/OUT connectors
r
These input and output multichannel digital audio in optical
format.
44.1, 48, 88.2, 96, 176.4 and 192kHz sampling frequencies
are supported.
SMUX2 is supported for formats up to 88.2/96 kHz, and
SMUX4 is supported for formats up to 176.4/192 kHz.
MIDI OUT jack
t
This 5-pin DIN is a standard MIDI output jack.
This outputs MIDI signals.
MIDI IN jack
y
This 5-pin DIN is a standard MIDI input jack.
Use this to input MIDI signals.
WORD IN/OUT connectors
u
These BNC connectors are for the input and output of word
clock and video reference signals.
Word clock signals of 44.1, 48, 88.2, 96, 176.4 and 192 kHz
can be input and output.
CAUTION
If a digital system has multiple word clock masters, serious
problems, including damage to equipment, could occur.
75Ω ON/OFF/THRU/WORD OUT switch
i
Use this switch to make the following settings.
o Whether or not the WORD IN connector has 75Ω termi-
nation
o WORD output THRU/OUT setting (OUT is for WORD only)
LINE IN 9-10 (BALANCED) jacks and LEVEL switch
o
These standard TRS jacks are line inputs.
Use the LEVEL switch to set the nominal level to −10dBV or
+4dBu.
COAXIAL OUT jack
p
This digital audio output connector supports the AES/EBU
and S/PDIF standards.
Set the digital signal format on the "INTERFACE" page of the
Settings Panel.
LINE OUT (BALANCED) 1–10 jacks
a
These standard TRS jacks are line outputs. The nominal
output level is +4 dBu.
(Tip: HOT, Ring: COLD, Sleeve: GND)
AUTO POWER SAVE switch
s
Use this switch to have the unit turn itself off automatically
(start standby) when operating in mic preamp mode if no
input signal above −60 dBFS is detected for 30 minutes.
CAUTION
If you want to turn the unit on again after it has turned itself
off (started standby) automatically, press the STANDBY/
ON button once, wait at least 8 seconds and then press the
STANDBY/ON button again.
Cord holder
d
Hook the cord of the included AC adapter here to prevent
accidental disconnection.
DC IN 12V connector
f
Connect the included AC adapter (GPE248-120200-Z) here.
7
TASCAM US-20x20